User guide

User Guide

Using the Arrow buttons on your Vulkano remote:

 Select It worked if the remote commands work

 Select It didn’t work if the remote commands

failed, and follow the instructions

 Select Try again to test the remote commands

again

 Select Continue anyway to skip the test and try

again later

 Press OK

TIME ZONE

Using the Arrow buttons on your Vulkano remote:

1. Select your time zone

2. Press OK

STORAGE

Your Vulkano needs to format the attached storage

device (hard drive or SD card) for recording. The

First-Time you configure your Vulkano, the Storage

screen may indicate that the attached device is “not

compatible”. This is normal.

 Press OK to proceed with formatting the

storage device

CONFIRM FORMATTING

Using the Number buttons on your Vulkano remote:

1. Enter the code number displayed on the screen

2. Press OK

Disk formatting may take up to ten minutes.

The Formatting Progress dialog box will be displayed.

| | |

| |

Numbers