Technical Specifications

Briar Valley Hickory
PRODUCT SPECIFICATION SHEET
Metric English
Thickness
8 mm
0.31 in
Width
204 mm
8.03 in
Length
1210 mm
47.64 in
Coverage per Carton
1.97 m²
21.26 ft²
HDF Board
CARB Phase 2 Compliant
Warranty
30 Year Limited Residential
Edges
8 mm Bevel
Wear Resistance Rating
AC 3
Planks per Carton
8
Cartons per Pallet
60
Use
Residential
Installation System
Glueless angle/tap locking system
Location
Below, on and above grade concrete, above
grade plywood and approved existing floors
• Place the packaged flooring flat in the room for a minimum of 48 hours prior to installation. Do not remove the plastic
wrapping. Be sure that the room temperature is in the range of 65-75°F (18-20°F) during acclimation and installation.
• Post-installation, room temperature must be maintained between 65°F and 85°F; laminate flooring should not be
installed in rooms where the relative humidity exceeds 70%.
• Rooms measuring wider or longer than 30 feet (9 m) require the use of T-moldings to allow for normal expansion and
contraction of the floor.
• Be sure to stagger boards by a minimum of 12 inches (300 mm).
• Allow a minimum of 5⁄16 inches (8 mm) expansion space around the perimeter of the room and any fixed objects such
as posts.
• When installing over concrete use a vapor barrier.
• Do not install cabinets directly on laminate flooring.
• Sweep, dust or vacuum the floor regularly with the hard floor attachment (not the beater bar) to prevent accumulation of
dirt and grit that can scratch or dull the floor finish.
• Use a damp cloth to blot spills as soon as they happen; never allow liquids to stand on the floor.
• Laminate flooring may be lightly damp-mopped with a mild household cleaner. Spray cleaner or water on mop or cloth
and not directly on the flooring. Never use steam mops, wet-jet type mops or any product that sprays water directly on to
the floor.
See product insert for complete installation and warranty information. For more information, call 1-877-356-0311