User`s manual

The monitor stand comes already attached to the back of the monitor. To

install the base, perform the following steps:

1. Place a blanket or towel on a flat surface (such as a table or the floor).

2. Place the monitor face down on the blanket or towel.

3. Swivel the stand up so that there is sufficient vertical space to install the

base.

4. Fit the base on the bottom of the stand and press it until it clicks into place.

To remove the base, perform the following steps:

1. Place a blanket or towel on a flat surface (such as a table or the floor).

2. Place the monitor face down on the blanket or towel.

3. Squeeze the two plastic clips on the bottom of the base and pull the base

off the stand.

MONITOR STAND & BASE