Users Manual

FN+9
Voice/Music/Noise controlled effect. FN+P
GUP/PGDN to change sensitivity.
FN+
→
Toggles direction of current animation effe
ct
FN+
←
Toggles direction of current animation effe
ct
FN+PG UP
Increases backlight animation speed
FN+PG DN
Decreases backlight animation speed
Custom Backlight Mode Instructions:
1. Press Fn + Z/X/C. Each key can store one backlight mode macro.
2. Press Fn+Tab. The blue LED indicator will flash repeatedly to indicate that backlight macro recording
has begun.
3. Press the keys that you wish to set backlighting for.
4. Press Fn+ Tab again to stop backlight macro recording.
Hot Keys
FN+WIN
Lock and unlock windows keys
FN+Backspace
Hold 3 seconds to reset keyboard
FN+Q/W/E
Switch Bluetooth profiles
FN+Z/X/C
Switch custom backlighting profiles
FN + Tab
Backlight macro recording and saving
FCC STATEMENTS:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditio
ns:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not installed and used in
accordance with the instructions,may cause harmful interference to radio communications.However,there is no
guarantee that interference will not occur in a particular installation.if this equipmemt does cause harmful
interference to radio or television reception,which can be determined by turning the equipment off and on,the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.