Users Manual

Collider Membrane Keyboard
–
QIG
Battery and Charging
• Battery – 4 days (2 hours per day) Bluetooth mode. Standby mode – 3 months
• Red LED indicator will illuminate when battery is charging.
• RED LED indicator will shut off when battery is fully charged
• “FN” key backlight LED will flash repeatedly when battery is low
• Backlights will shut off after 5 minutes without use to conserve batter. After 30 minutes
without use keyboard will enter standby mode and disconnect from Bluetooth. Press any
key to exit standby mode and wake up the keyboard.
Bluetooth Pairing Instructions
1. Set switch on the back of the keyboard to the “ON” position
2. Press and hold FN + P for 3-5 seconds
3. The “P” key will begin to flash repeatedly to indicate that the keyboard is ready to conn
ect to a new device over Bluetooth.
4. On the device you wish to connect to, search for Bluetooth devices and select “ Collide
r 65” to pair the device.
5. Once the keyboard has connected to the device, the “P” ley will stop flashing to indicat
e successful Bluetooth pairing.
6. The keyboard can support Bluetooth connections for up to three devices. Press and hol
d FN+P and Q/W/E to set up a connection to a new device.
7. Switch previously paired devices by quickly pressing FM + Q/W/E
RGB Backlighting and Animation Effects
FN+DEL
Cycle backlit modes
–
Breathing. Cycle, Ra
inbow. Sparkle, Glitter, Colorful, Wave, Ch
ase, Ripple
FN+INS
Cycle backlit modes -
Static, Single-on, Sin
gle-off. Rotate, Scroll, Roll, Fall, Colorful, Glitt
er
FN+PG UP
Breathing animation effect
FN+PG DN
Running animation effect
FN+
↑
Cycle through single color mode
–
Red,
Green, Blue, Yellow, Cyan, Pink, White
FN+
↓
Expanding animation effect
FN+
→
Custom mode. Six-are backlit color
FN+
←
Blastoff animation effect