User Manual

Dual Extrusion Tab

 Standby Temperature (°C): Sets the temperature of the second extruder when not

actively printing.

 Prime Tower Size (mm): This is the extrusion width of the prime tower. The prime

tower is a location that the printer will use to switch nozzles during dual extrusion

to prevent a gap in the model by printing a small amount of filament at the prime

tower location.

 Ooze Shield Distance (mm): This is the size of the circle of protection layers printed

on the edge of the model.

 Support Extruder: Selects which extruder to use for printing support structures.

 Support Interface Extruder: Selects which extruder to use for printing supports.

 Build Plate Adhesion Extruder: Selects which extruder to use for printing the initial

layer.

 Infill Extruder: Selects which extruder to use for printing the infill.