User Manual

Line Width Tab

 Outer Wall Line Width (mm): This is the width of the outermost wall line. By

lowering this value, higher levels of detail can be printed.

 Inner Wall(s) Line Width (mm): This is the width of a single wall line for all walls

except the outermost wall.

 Top/Bottom Line Width (mm): This is the width of the top and bottom lines.

 Infill Line Width (mm): This is the width of a single infill line.

 Support Line Width (mm): This is the width of a single support structure line.

 Skirt/Brim Line Width (mm): This is the width of a single skirt or brim line.

 Raft Top Line Width (mm): This is the width of the lines in the top surface of the raft.

These lines can be thin so that the top of the raft is smooth.

 Raft Middle Line Width (mm): This is the width of the lines in the middle raft layers.

Making the second layer extrude more causes the lines to stick to the build plate.

 Raft Base Line Width (mm): This is the width of the raft base layer. These should be

thick lines to assist with build plate adhesion.

 Prime Tower Line Width (mm): This is the extrusion width of the prime tower.