User Manual

Material Tab

 Filament flow (%): Sets the flow rate of filament in the melting state. This is set

according to the type of filament being used. In general, the flow rate for PLA or

PLA Pro is 90 and the flow rate of ABS is 100.

 Filament Diameter (mm): Sets the diameter of the filament being used. This printer

only supports 1.75mm diameter filament.

 Auto Change Temperature: When printing, the nozzle will automatically change the

printing temperature according to the type of filament being used. General

consumable are set by default, so there is no need to select this option.

Travel Tab

 Combing Mode: This option determines how the nozzle will move when not

printing. The Off option has the nozzle move the shortest distance between the

previous extrusion location and the new start location. The All option causes the

nozzle to move along anything it has already extruded. The No Skin option will

avoid the outer layers to move the nozzle to the new start location, which can

greatly improve print quality.