User Manual

 Support Infill Speed (mm/s): Sets the printing speed of infill inside the model

supports.

 Support Interface Speed (mm/s): Sets the printing speed of the top and bottom

surfaces of the model supports.

 Initial Layer Speed (mm/s): Sets the printing speed of the first layer of the model.

 Travel speed (mm/s): Sets the movement speed of the nozzle when not printing.

Infill Tab

 Infill Pattern: Use the drop-down menu to select one of seven different infill

patterns, including Lines, Grid, Triangles, Zig Zag, Concentric, Cross, and Octet. The

individual patterns are illustrated in the table below.

 Infill Before Wall: Check this box to print the model after filling and printing the

outline.

 Outer Before Inner Walls: Check this box to print the exterior walls before printing

the interior walls.

 Gradual Infill Steps: For models that need to gradually change the fill rate, this value

determines how many layers to change at once.