User Manual

INSTALLATION

1. Place the Base (B) on a desk or table.

2. Insert the Pole Assembly (C) into the hole in the base, then

turn it clockwise to tighten the connection.

3. Place the Arm Assembly (A) and Head Assembly (D) onto the

Pole Assembly (C), adjust the height as desired, then use the

5mm Hex Wrench (H) to tighten the screw as shown in the

accompanying image. You can also adjust the height by

loosening the lock collar and extending the pole assembly up or down as desired.

4. Place a towel or blanket on a table or on the floor, then place one of your monitors

face down on the towel/blanket.

5. Insert two (2) Short M4x12 Screws (F) or Long M4x16 Screws (G) into the upper two

VESA mounting holes. Tighten them to the point where there is 2-4mm between

the back of the monitor and the screw head. If necessary, use the ø8.0 x ø5.5 x 5.0

mm Bushings (E) to reduce the space between the screw heads and the back of the

monitor.

6. Repeat steps 4 and 5 for the other three monitors.