User`s manual

MONOPRICE 10707 Windows User's Manual

9. Hardware Installation

After you have installed the software driver and utility to your system, power it off before

installing the hardware.

1. Ensure that your computer is powered OFF.

2. Position the monitor so that you can easily access the connections on the rear.

3. Plug one end of the included VGA cable into the VGA input port on the monitor

and plug the other end into the VGA output port on your computer. Tighten the

thumbscrews on each connector to ensure that they do not come loose.

Note: Alternatively, you can use a DVI cable (not included). Your video card

should be capable of producing DVI-A or Single Link DVI-D signals.

4. Plug one end of the included USB cable into the USB port on the monitor and the

other end into an available USB port on your computer.

5. Plug the DC barrel connector on the AC adapter into the DC IN port on the back

of the monitor.

6. Plug the C13 connector on the AC power cord into the AC adapter. Plug the other

end into an AC power outlet.

7. Press the Power button on the monitor, then power on your computer.