Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs MONOPRICE Self Amplified Digital Keypad with Bluetooth and Analog Inputs PID 10222 1
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs INTRODUCTION This Self-Amplified Digital Keypad features a 6 watts/channel amplifier, a Bluetooth audio receiver, and three analog audio inputs. It provides an easy to connect central location for playing back audio material from a variety of portable sources. IR repeater functionality allows a remote source device to be controlled using its standard IR remote control.
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs SAFETY WARNINGS 1. This device is intended for indoor use only. Do not expose this device to water or moisture of any kind. 2. Ensure that the wire connections are clean, with no stray wire strands anywhere. 3. Double check all connections before applying power. 4. Do not provide a speaker load lower than 4 ohms to the amplifier. Doing so can cause damage to the amplifier and could result in a fire. 5.
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs CONTROLS AND CONNECTIONS Stereo RCA Inputs Volume Level Display 3.
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs INSTALLATION 1. Connect a pair of speaker wires from the installed speakers to the OUTPUT terminal block on the device. Pay close attention to left/right orientation and ensure that the +/- polarity is properly maintained. 2. Obtain a 24 VDC power source (not included). Connect the positive output of the power source to the V+ terminal and the negative output to the G terminal. Once power is applied the unit will be in standby. 3.
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs CONNECTION DIAGRAM 6
Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs OPERATION 1. Press the power button on the device to turn it on. The orange backlight behind the digital display will be illuminated when power is on. 2. (Optional) Establish a Bluetooth connection between your mobile device and the amplifier unit by performing the following steps: 2a. Ensure that your Bluetooth capable device is within 3 feet of the amplifier/Bluetooth Receiver. 2b.
