Spec Sheet

PAGE 6 OF 7 Product Specication Revised 10/21
For questions about your
appliance, please call 1-800-626-2000.
INSTALLATION WITH STATEMENT WALL OVEN
AND STATEMENT ADVANTIUM
PRODUCT FRONT VIEW
(WALL OVEN & DRAWER HAVE ACCESSORY FLUSH WALL OVEN TRIM)
29 3/4”29 3/4”
20 1/4”
27 1/16”
6 11/16”
28 3/8”
1/8”
1/8”
1 5/16”
HELPFUL TIPS
A
Install an anti-tip block against rear
wall, 5 5/8" from oor of cutout to
bottom of block. The anti-tip block
must be installed to prevent the drawer
from tipping forward when opened and
loaded. Failure to add the anti-tip block
could result in personal injury.
B
The storage drawer may be supported by
either a solid bottom or 2"x2" or 2"x4"
runners. The support must be level and
rigidly mounted, ush with the bottom
edge of the cut-out (there is no way
to level the drawer once it has been
installed, so make sure that the supports
are level). The oor or runners must be
capable of supporting at least 65 lbs.
C
Cabinet surfaces must be an appearance
nished surface for ush installation.
Cleats may be visible and should be
nished to match cabinetry.
D
For optimal nished appearance, Wall
Oven must use ZX30VT1 ush vent
trim accessory.
For more details refer to the installation
instructions for this product.
Drawer bottom cleat
(Bottom cleat is set
back from top and
side cleats.)
2 3/4”
Side cleat
Top cleat
Advantium bottom cleat
FLUSH INSET INSTALLATION
FRONT VIEW
FLUSH INSET INSTALLATION
SIDE VIEW
5 15/16”
Opening
height
Side cleat
23 9/16” Min
Flush inset depth
2 3/8”
Side cleats
1 7/8”
Top cleat
1 1/2”
Advantium bottom cleat
(Extends full depth of cabinet)
17 1/2”
Opening
height
28 1/2”
Cutout width
3/4”
Side cleats
3/4”
Side cleats
1 1/8”
Top cleat
1/4”
Bottom cleat
(Extends full depth of cabinet)
28 1/2”
Cutout width
25 1/4”
Cutout width
27 1/4”
Opening
height
28 5/8”
Flush inset
height
1 13/16”
Bottom cleat extends full
depth of cabinet and is set
back
2 3/4” from cabinet face.
6 5/16”
Side cleat
height
A
5 5/8”
Anti-Tip
Block
FLUSH INSET INSTALLATION
TOP VIEW
1 7/16”
Cleat depth
1 7/16”
Cleat depth
2 3/4”
Drawer bottom cleat depth
Side cleatSide cleat Center cleat
Bottom cleat can be
either solid platform
or 4” wide runners.
B
C
D