Specifications

Installation Instructions

[STEP 2] CONNECT ELECTRICAL

Verifg that power is turned off at the source.

WARNING: ,fhouse wiring is not

2-wirewith a ground wire,an electricianwillneed

toconvertexistingwiringto meet thesespecs.

When house wiringisaluminum, be sureto

use U.L approved anti-oxidantcompound

and aluminum-to-copper connectors.

AVERTISSEMENT:

Si le cablage de la maison n'est pas un cablage

5 deux ills avec un fil de terre, un @lectricien

doit convertir votre cablage existant 5 ces

caract@istiques techniques. Si le cablage de votre

maison est en aluminium, assurez-vous d'utiliser

un compos@ anti-oxgdant approuv6 et des

raccords aluminium _ cuivre.

I. Place insert sleeve on padded, get stable, surface

below cutout (can use flattened carton to pad

surface).

2. Remove the junction box cover

00000

4. Connect white leads to branch circuit white lead.

5. Connect blackleadsto branch circuit blacklead.

6. Connect green/yellow leads to branch circuit green

lead.

7. Secure all connections with wire nuts on each

electrical connector

00000

Cover

Screws

Wires

3. Pull house wires through wall of insert sleeve and

attach the strain relief. Thread the house wire

through the junction box.

8. Carefully push wires intojunction box and replace

cover

9. Secure junction box cover with original screws.