Dispatcher

ZVC36LSSMONOGRAM 36" CUSTOM HOOD INSERT
Listed by
Underwriters
Laboratories
Product Specification Revised 1/18
Opening
CUSTOM INSERT LINER DIMENSIONS AND SPECIFICATIONS (IN INCHES)
OUTSIDE DIMENSIONS
THE INSERT SLEEVE
The bottom edge of the insert sleeve has a 7/8" wide
flange on the sides and a 1/2" wide flange on the front
and back.
REMOTE LOCATION FOR THE CONTROL
The control may be removed from the hood and
installed into a wall or countertop. A 30-ft length of
wire is supplied to accommodate most installations. A
blanking plate covers the opening when the controls
are removed. The overall size of the control is 4-1/4"
wide and 2-1/4" deep.
3'-11/16"
1'-11/16"
Control Cutout
We recommend that the cutout in granite or other hard
surfaces be made before the countertop is installed.
THE SUPPLIED LINER
A stainless steel liner is shipped with each hood insert.
This non-combustible liner protects the underside of
the canopy.
CUSTOM LINER
If you are not using the supplied liner, you may
construct a custom non-combustible liner. Use the
supplied liner as a template. The opening must be
26"W x 13-3/16"D. 3/4" thick material must surround
the opening to allow the sleeve locking clips to
engage. The insert sleeve inside the cabinet should be
positioned 1/2" from the rear wall so that the center of
the 8" duct is 5-1/2" from the rear wall.
The custom canopy must be sized to fit the insert sleeve.
Construct the canopy with an opening that is:
26"W x 13-3/16"D
The opening must be constructed of 3/4" thick material
to allow the sleeve locking clips to engage.