Installation Sheet

18 49-80329 Rev. 5
Installation Instructions
1
MOUNT TEMPLATE
Ŷ$OLJQWKHWHPSODWHZLWKWKHPDUNVRQWKHFHLOLQJDQG
tape in place.
– Be sure the template is oriented correctly with the
front of the hood.
Ŷ8VHDSOXPEEREWREHVXUHWKHPRXQWLQJKROHV
will provide parallel alignment with the countertop
below.
Ŷ&HQWHUSXQFKDOOKROHORFDWLRQV
Ŷ'ULOOSLORWKROHVLQWKHVFUHZORFDWLRQV8VHD´
ELWDQGGULOODSSUR[LPDWHO\´GHHS
Ŷ'ULYHKH[KHDGZRRGVFUHZVLQWRWKHFHQWHURIWKH
FHLOLQJMRLVWVDQGFURVVIUDPLQJ/HDYHD´JDSWR
allow the screw head to engage the keyhole slots on
the support frames.
Ŷ&XWWKH´GXFWRSHQLQJWKURXJKWKHVKHHWURFN
2
ADJUST FRAME HEIGHT
Ŷ0HDVXUHH[DFWFHLOLQJKHLJKW
Ŷ)LQGWKHH[DFWIUDPHKHLJKWUHTXLUHG
RQWKHFKDUWRQSDJH
Ŷ5HPRYHVFUHZVRQHDFKRIWKH
sides of the frame to loosen the upper
VWUXFWXUHORZHUVWUXFWXUHDQGEORZHU
motor.
Ŷ$GMXVWWKHKHLJKW³;´DFFRUGLQJWR
WKHFKDUWRQSDJH8VHDWRWDORI
32 screws (8 screws on each side)
WRVHFXUHWKHXSSHUVWUXFWXUHORZHU
structure and blower/motor together.
INSTALLATION—VENTED TO THE OUTSIDE
1/4" Gap
49-80406 Printed in Italy 04-06 JR
36≤ Hood
Template
8-1/2
≤
Dia.
Cut a 1≤Dia.
Wire Access
Hole
Cut a 1≤Dia.
Wire Access
Hole
Drill 3/16≤
Pilot Holes
Approx. 1-1/2≤
Deep
Drill 3/16≤
Pilot Holes
Approx. 1-1/2≤
Deep
10-1/16≤ to
Centerline
of Holes
7-1/16≤ to
Centerline
of Holes
FRONT OF HOOD
7-1/16≤ to
Centerline
of Holes
24"min.
PD[
36"min.
)UDPH
height
2-3/4"
Ceiling
height
X
Mark
each
piece to
indicate
where
screw
holes
align.
NOTE: Low ceilings may require that the
lower portion of the support frame be removed.
The upper support frame may be secured
directly to the blower/motor. Refer to the
FKDUWRQSDJHIRU\RXUFHLOLQJKHLJKWDQG
to be sure the duct cover trim piece will fit.