Owner`s manual

Installation Instructions

INSTALLATION - RECIRCULATING

I_l INSTALL FILTERS

• There are two channels inside the back and front of the

hood. These channels will hold the charcoal filters and

stainless steel grease filters in place.

Upper charcoal

filter channel

Lower charcoal

filter channel

Install charcoal filters

• Remove protective film on the charcoal filters.

• Tip charcoal filters into the upper (top} channels at the

rear of the opening. Grasp the filter tab, lift and pull

forward until it rests in the front upper channel.

• Install all 3 charcoal filters.

Upper charcoal

filter channel "--.

Grasp tab,

lift and pull forward

Install grease filters

• Remove protective film from grease filters.

• Tip the grease filter into the lower channel at the rear of

the opening. Push back, lift and pull the knob forward

until the filter rests on the channel.

• Install all 3 grease filters.

• Turn power on. If the filter light on the control panel glows,

adjust the right-side filter in the channel to engage the

switch arm.

filter channel

I_ FINALIZE INSTALLATION

• Remove protective film covering the control panel

on the front face of the hood and ang remaining

packaging materials.

• Make sure the filters are seated properlg when

installed and the filter light is not on.

• Be sure fan and lights operate correctlg. Refer to

the Owner's Manual for operating instructions

and the Problem Solver.