Owner`s manual

Installation Instructions

INSTALLATION - RECIRCULATING

_-1 INSTALL DECORATIVE DUCT COVERS

Pretap _

2 Screw

Holes

TopDuct

Install Screwon

EachSide

Bottom Duct

Cover

Bottom DuctCover

! !

_ !_!ieaHIwlS_iJne

• Pretap or drive decorative screw into the screw holes

on the support frame. This will make screw installation

easier.

• Seporate the two decorative duct covers.

• Select the inside or top cover with the vent hole

pattern on one end.

For this recirculating installation, the hole pattern

should be located at the top.

• Locate the 2 supplied duct cover screws.

• Slide the decorative duct cover over the support frame

and push to the ceiling.

• Attach the inside duct cover to the hood support at

the top with 2 supplied duct cover screws.

• Locate the stop screw in the hardware bag.

• Install the stop screw into one of the two holes and

tighten against the frame to allow the second duct

cover to slide up and pass over.

• Slide the lower duct cover over the installed upper

duct cover and push up past the stop screw location.

• Back out the stop screw far enough to support the

bottom duct cover and prevent it from sliding down

onto the top of the hood.

CAUTION: The stop screw must be

installed. Failure to do so could result in personal

injurg or damage to the duct cover.