Owner`s manual

Installation Instructions
INSTALLATION -VENTED TO THE OUTSIDE
SECURE WIRING
• Route house wiring through the ceiling hole and
pull o length to reach the hood junction box.
FrontSide
Support-
Frames
?
0
?
U
Ce!ling
\\\
?
0
?
--- :
House
Wiring
• Tape the wire to the front of the frame support to
prevent damage during installation and service.
_-1 SIZE AND INSTALL DUCTWORK
• Measure from house duct (Dim. A) to bottom of
support frame.
- Add at least 1" for duct overlap at the top.
- Subtract 3/4" for hood insertion into the bottom
of the frame.
• Cut the 6" dia. duct to the required length.
HouseDuct--
Side
View
Support
Frame
Ceiling
/
.=
Dim.A i Length
DuctConnection
ToHood........ /="[_]
................................................................3/d_]]_
BottomSupport
FrameFlange
NOTE: The bottom end of the duct must be flared
slightlg, to facilitate installation of the hood.
• Install duct up through support frames onto the
house duct. Push duct up until it is 3/a" from the
bottom of the support frame flange.
• Secure the duct to house duct connection with
screws and seal with duct tape.
• Seal duct connection with duct tape, making sure
connection is secured in place.
13