Installation Instructions

8
REMOVE THE PACKAGING
• Remove packages from the “V” shaped cardboard
section. Remove shipping pads.
• Lift the hood out of the box.
IMPORTANT: Lift the hood by grasping
the outside edges of the exhaust opening on the top.
• The vent hood motor is shipped secured to the skid with
4 screws. Locate and remove 2 screws on each side of the
motor. Discard the shipping skid and screws.
• From the inside of the hood, loosen (do not remove)
the 2 screws holding the wood mounting support to the
back of the hood. Remove and set aside the mounting
support with screws for later installation. DO NOT
DISCARD.
• Remove tape and packing material from the hood and
all supplied parts.
Hood
Parts
Wood
Mounting
Support
Motor
Mounted
on Skid
Shipping Carton
Duct
Transition
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and tape measure
Pliers
Electric or battery operated drill
and 1/8", 3/8" bits
120V 60Hz. 15 or 20 Amp,
2-wire with ground. Properly
grounded branch circuit.
Key Hole Saw
Hammer
Wire cutter/stripper
Step ladder
Metal Snips
Saber saw
or Sawsall
Wire nuts
Phillips and flat
blade
screwdrdivers
Strain relief for
junction cover.
Spirit level
Flashlight
Safety glasses
10" round metal
duct, length to
suit installation.
Duct tape