Installation Instructions

8
REMOVE THE PACKAGING
•Removepackagesfromthe"V"shapedcardboardsection.
Remove shipping pads.
•Liftthehoodoutofthebox.
IMPORTANT:Liftthehoodbygrasping
theoutsideedgesoftheexhaustopeningonthetop.
•Theventhoodmotorisshippedsecuredtotheskidwith
4screws.Locateandremove2screwsoneachsideof
themotor.Discardtheshippingskidandscrews.
•Greaseltersmustberemoved.Graspthelatch,pullthe
lterupandliftout.
•Lifttoremovethegreasetrays.Setgreaseltersand
traysasideforlaterinstallation.DONOTDISCARD.
•Fromtheinsideofthehood,loosen(donotremove)the2
screws holding the wood mounting support to the back
of the hood. The screws should be backed out of the
woodto1/4".Removethesetasidethemountingsup-
portwithscrewsforlaterinstallation.DONOTDISCARD.
•Removetapeandpackingmaterialfromthehoodandall
supplied parts.
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencilandtapemeasure
Pliers
Pliers
Electric or battery operated
drilland1/8",3/8"bits
120V 60Hz. 15 or 20 Amp,
2-wirewithground.Properly
grounded branch circuit.
Electrical Cable
Key Hole Saw
Key Hole Saw
Hammer
Wire Cutter/Stripper
Wire cutter/
stripper
Step ladder
Ladder
Metal Snips
Metal Snips
Saber saw
or Sawsall
Saber Saw
Wire nuts
Wire Nuts
Phillipsandat
blade screwdrivers
Strain relief for
junction cover.
Spirit level
Level 2
Flashlight
Safety glasses
Safety Glasses
762Dia5
10"round
metal duct,
length to
suit installation.
Ducttape
Duct Tape
Hood
Parts
Wood
Mounting
Support
Motor
Mounted
on Skid
Shipping Carton
Duct
Transition