Installation Instructions

STEP 9 INSTALL SHELF "ONLY" STEP 10 INSTALL IMPLEMENT RODS

•Removeshelfpackagingandprotectivelm.

•Ifinstallingtheshelfalone,withoutthebackguard,place

shelf against the bottom of the hood and mark the

screwholelocations"B"onthewall.

•Drilltwo1/8"pilotholes.

•Ifthedrilldidnotenterthestuds,enlargeholesto3/8".

•Insertthewallanchorsintotheenlargedholes.Remove

the screws from the wall anchors.

•Install2shoulderscrewsintoholes"D"inthebottomof

thehoodangeleaving1/8"gap.

•Engageshoulderscrewsintothekeyholeslotsinthetop

of the shelf. Slide the shelf towards the left to lock into

place.

•Installtwo3/4"longmachinescrewsthroughthebottom

oftheshelfintothebottomhoodangelocation"E".

•Useaatbladescrewdrivertoinstallthestand-osinto

the bottom of the hood.

•Aligntheimplementrodtothestand-oswiththescrew

hole towards the inside of the hood. Secure the rod to

thestand-oswiththesuppliedAllenwrench.

•Followthesameprocedureontheoppositeside.

FINALIZE INSTALLATION

•Installthesuppliedinfraredbulb(s).

•SeetheOwner’sManualforinstructionstotest

operation.

1/8"

Gap

Mounting

Holes

for Shelf (B)

Screw

Stand-offs

Into

Hood

Use Allen

Wrench to

Secure Rod

to Stand-offs