Installation Instructions

ManualsBrandsMonogram ManualsRange HoodsMonogram 1090 CFM 48 Inch Wide Under Cabinet Range Hood with Utensil Racks and Removable Grease Trays

STEP 7 INSTALL FILTERS

STEP 8 INSTALL BACKGROUND AND SHELF

•Dropgreasetrayintothehood.Thereartabsshould

engage the slots in the hood track.

INSTALL BACKGUARD:

•Removepackaging.

•Placebackguardagainstthebottomofthehoodtouse

asatemplate.Markupperscrewlocations"A"and"B".

•Removebackguard.

•Drillfour1/8"pilotholesatscrewlocations"A"and"B".

•Ifdrilldidnotenterstuds,enlargetheholesto3/8".

•Insertthewallanchorsintotheenlargedholes.Remove

screws from the wall anchors.

•Alignandsecurethebackguardtothewallusing2wall

anchorscrewsorwoodscrewsinlocations"A".

•For30"and36"models,install2screwsthroughhole

locations"C"atthebottomofthebackguard.For48"

models, install 4 screws.

INSTALL SHELF OVER BACKGUARD:

•Installtwoshoulderscrewsintoholes"D"inthebottom

ofhoodangeleaving1/8"gap.

•Removeshelfpackagingandprotectivelm.

•Engageshoulderscrewsintothekeyholeslotsinthe

top of the shelf. Slide shelf towards the left to lock into

place.

•Installtwo3/4"longmachinescrewsthroughthebot-

tomoftheshelfintothebottomhoodange,location

"E".

•Installanchorscrewsthroughtheshelfandintothe

wallholes"B".

•Removeallprotectivelm.

•Insertthegreaselterintotheopeninganddropinto

thebottom.Raiseltertothetopandlockintoplace.

•Toremovethelters,graspthehandle,pushthelter

up and lift out.

This hood can be installed with the warming shelf

andbackguardtogetherorwiththewarmingshelf

orbackguardalone.

•Ifinstallingthebackguardalone,withouttheshelf,

drive screws in all locations shown.

Mounting

Holes for

Backguard (A, C)

and Shelf (B)

BACKGUARD

1/8"

Gap