Installation Instructions

10
•Usealeveltodrawthecooktopcenterlinelocation.Draw
the line to ceiling height.
•Measuredesireddistancefromthebottomofthehood
to the cooking surface.
Note: If you are installing the hood with duct covers, be sure to
read“UsingDuctCoverAccessories”page7.Exactinstallation
height may be determined by use of one or more duct covers.
•Determinebottomof
hoodlocation(Dimen-
sionA)bysubtract-
ing12-1/2"fromthe
desired installation
height.
•Usealeveltodraw
a straight horizontal
pencil line indicating
the bottom of the
hood.
•Fromthelineindicatingthebottomofthehood,mea-
sure20"upanddrawanotherlineforthelocationofthe
wood support. See illustration.
STEP 1 DETERMINE HOOD, DUCTWORK AND WIRING LOCATIONS
FOR VERTICAL (Straight Up) DUCTING:
•Usealeveltodrawacenterlinefromthebottomofthe
hoodtoceilingorsot.
•Ifventingouttheceiling,extendthecenterlineforwardon
theceilingorsot.
•Locatethecenterlineofa10-1/2"holeontheceilingor
sotbymeasuring6"fromthewall.
FOR DUCTING THROUGH REAR WALL:
•Measure9-7/8"abovethemarkedlineforthetopofthe
hood.Atthecenterline,marklocationfora10-1/2"diam-
eter hole.
House Wiring Location:
•Thejunctionboxisfastenedtothebackofthehoodon
the right side.
Installation Instructions
AlternateKnockoutLocations
Iftheinstallationrequires,thejunctionboxcanberelocated
from the back to the top of the hood. Remove 3 screws,
alignboxtotopknockoutandsecurewithoriginalscrews.
•Removejunctionboxcoverandknockout.Installstrain
relief.
•Therecessedbacksideofthehoodprovidesalargearea
forthehousewiringtoexitthewallandberoutedtothe
rearknockoutandjunctionbox.
•Thelocationforthehousewiringdependsontheinstal-
lation height of the hood and the width of the hood.
•Removejunctionboxcoverandknockout.Installstrain
relief.
Dim. A
Installation
Height
*See recessed
location below.
Top of Hood
Bottom of Hood
22-1/2"
20"
Wood
Support
*House Wiring
Location
Dimension A
Cooking Surface
9-7/8"
14-1/4"
14" for 48" Models
8" for 36" Models
5" for 30" Models
Electrical
Area
6-1/2"
18-1/16" for 48" Models
12-1/16" for 36" Models
9-1/16" for 30" Models