Installation Instructions

8
REMOVE THE PACKAGING
•Liftoutthewoodencrossmember,aswellasthetoppro-
tective carton.
•Liftoutthefour“L”shapedpolystyreneprotectionproles.
•Removetheprotectionmoldingsaroundthesmallercar-
tonbox.
•Removethesmallboxhousingthemotor.
•Liftthehoodoutofthebox.
CAUTION:Liftthehoodbygrasping
the outside edges of the inlet opening of the hood.
Donotliftthehoodbytheexhaustopeningdivider—
damage will occur!
•Removetheshippingscrewsholdingthewood
mounting piece to the back side of the hood.
Set aside the wood mounting piece and screws
for later installation. Do not discard.
•Removethe“V”shapedcartoninsert.
•Removethepartspackagefromthe“V”shaped
cardboard insert.
•Removethejunctionboxcoverandknockout.
•Installthestrainreliefontothebackortopofthehood.
•Removealltapeandpackingmaterialfromthehood,duct
transition and motor.
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencilandtapemeasure
Pliers
Pliers
Electric or battery operated
drilland1/8",3/8"bits
120V 60Hz. 15 or 20 Amp,
2-wirewithground.Properly
grounded branch circuit.
Electrical Cable
Key Hole Saw
Key Hole Saw
Hammer
Wire Cutter/Stripper
Wire cutter/
stripper
Step ladder
Ladder
Metal Snips
Metal Snips
Saber saw
or Sawsall
Saber Saw
Wire nuts
Wire Nuts
Phillipsandat
blade screwdrivers
Strain relief for
junction cover.
Spirit level
Level 2
Flashlight
Safety glasses
Safety Glasses
762Dia5
10"round
metal duct,
length to
suit installation.
Ducttape
Duct Tape
Wood
Mounting
Support
Motor
Hood
Parts
Package
Shipping Carton