Installation Instructions

12
Installation Instructions
STEP 2B Alternate Mounting Method
“A” Centerline to Stud
and Keyhole Slots
“B” Hood Width At
the Top
ZV48T 19-9/16" 40"
ZV48S 23-9/16" 47-15/16"
ZV36T 13-9/16" 28"
ZV36S 17-9/16" 35-15/16"
ZV30T 10-9/16" 22"
ZV30S 14-9/16" 29-15/16"
INSTALL HOOD TO SOFFIT OR BENEATH CABINETS
SKIP THIS STEP IF USING WALL MOUNTING METHOD
When necessary, the hood may be installed so that it is
supportedbythesot.
•Thesotshouldbeconstructedwith2x4’s.
•Determinetheinstallationlocationonthewall.
•Continuethecenterlineforwardonthebottomofthe
cabinetorsot.
•Theopeningabovethehoodshouldallowforthe10"
round duct and clearance to slide the hood back against
the wall.
A
Requires 10-1/2" Min.
Opening For Ductwork
and Hood Installation
A
•The2x4studsmustbelocatedasshowninthechart,
Dim.A.toacceptmountingscrews.
IMPORTANT:Sotframingmustbecapableof
supporting up to 150 lbs.
•Drill1/8"pilotholesintothestudsatthelocationsshown
in the top view illustration.
Install Transition Onto Top of Hood
•Placethetransitionpieceoverthehoodexhaustandse-
cure with 4 screws provided.
•Useducttapetosealtheconnection.Checktobesurethe
damper moves freely.
MountHoodontoSotorCabinet
Note: If mounting to the underside of a cabinet with a re-
cessedbottom,installshimstollthegap.
Duct
Transition
Top of
Hood
•Drivemountingscrewsintothestudsuntiltheyprotrude
1/4".The1/4"gapwillprovideclearancetoengagethe
keyhole slots in the top of the hood.
•Lifthoodtoinstallationposition.Locatehousewiringand
routethroughtheknockout(fromthebackortopofthe
hood).
•Lifthoodontomountingscrews.Slidebackagainstthe
rear wall.
•Tightenmountingscrews.
IMPORTANT: For additional support and to
minimize vibration during operation, the hood must
besecuredtothebackwall.Usewallanchorsto
fastenbottombackofhoodtothewall.
1/4" Gap
Push Back
to Wall
Add Shims
If Bottom
Is Recessed
Back
Wall
Cabinet
or
Soffit
Engage Top
Keyhole Slots
2"
7-1/2"
A
C
B
2-9/16"
8"
8-1/8"
6"
Back of Hood
Top View
Front of Hood
IMPORTANT: Remove
shipping tape from
damper and check that
damper moves freely.