Installation Instructions

10
•Usealeveltodrawthecooktopcenterlinelocation.Draw
the line to ceiling height.
•Measuredesireddistancefromthebottomofthehood
tothecookingsurface,30"min.to36"max.
Note: If you are installing the hood with duct covers, be sure to
read“UsingDuctCoverAccessories”page7.Exactinstallation
height may be determined by use of one or more duct covers.
•Usealeveltodrawastraighthorizontalpencillineindi-
cating the bottom of the hood.
•Fromthelineindicatingthebottomofthehood,measure
15-3/8"upanddrawanotherlineforthelocationofthe
wood support. See illustration.
FOR VERTICAL (Straight Up) DUCTING:
•Usealeveltodrawacenterlinefromthebottomofthe
hoodtoceilingorsot.
•Ifventingouttheceiling,extendthecenterlineforward
ontheceilingorsot.
•Locatethecenterlineofa10-1/2"holeontheceilingor
sotbymeasuring6"fromthewall.
STEP 1 DETERMINE HOOD, DUCTWORK AND WIRING LOCATIONS
FOR DUCTING THROUGH REAR WALL:
•Measure9-7/8"abovethemarkedlineforthetopofthe
hood.Atthecenterline,marklocationfora10-1/2"diam-
eter hole.
House Wiring Location:
•Thejunctionboxisfastenedtothebackofthehoodon
the right side.
Installation Instructions
AlternateKnockoutLocations
Iftheinstallationrequires,thejunctionboxcanberelocated
from the back to the top of the hood. Remove
3screws,alignboxtotopknockoutandsecurewithoriginal
screws.
•Removejunctionboxcoverandknockout.Installstrain
relief.
18-13/16" for 48" Models
12-13/16" for 36" Models
9-13/16" for 30" Models
Electrical
Area
8-3/8"
6-1/2"
18-1/16" for 48" Models
12-1/16" for 36" Models
9-1/16" for 30" Models
•Therecessedbacksideofthehoodprovidesalarge
areaforthehousewiringtoexitthewallandberouted
totherearknockoutandjunctionbox.
•Thelocationforthehousewiringdependsontheinstal-
lation height of the hood and the width of the hood.
•Removejunctionboxcoverandknockout.Installstrain
relief.
*Dependingon
Hood width and
Installation Height.