INSTALLATION INSTRUCTIONS 30”, 36” and 48” Professional Vent Hood MONOGRAM.
Safety Information BEFORE YOU BEGIN Read these instructions completely and carefully. Ŷ IMPORTANT — Save these instructions for local inspector’s use. Ŷ IMPORTANT — Observe all governing codes and ordinances. Ŷ Note to Installer — Be sure to leave these instructions with the Consumer. Ŷ Note to Consumer — Keep these instructions with your Owner’s Manual for future reference. Ŷ Skill Level — Installation of this appliance requires basic mechanical and electrical skills.
Consignes de sécurité AVANT DE COMMENCER Veuillez lire attentivement ces instructions dans leur intégralité. Ŷ IMPORTANT — Veuillez conserver ces instructions pour afin que l’inspecteur local puisse s’y référer.
Información sobre Seguridad ANTES DE COMENZAR Lea estas instrucciones en su totalidad y atentamente. Ŷ IMPORTANTE — Conserve estas instrucciones para uso del inspector local. Ŷ IMPORTANTE— Cumpla con todos los códigos y ordenanzas gubernamentales. Ŷ Nota para el Instalador — $VHJ~UHVH GH TXH HO Comprador conserve estas instrucciones.
Design Information CONTENTS 3URGXFW 'LPHQVLRQV ..................................................... 3 3DUWV 3URYLGHG .............................................................. 4 +DUGZDUH 3DFNDJH ....................................................... 4 Tools and Materials Required ...................................... 5 Installation Clearances ................................................. 6 2SWLRQDO 'XFW &RYHU $FFHVVRULHV ................................
Installation Preparation PARTS PROVIDED Locate the parts packed with the hood. Wood Support with Original Screws 2 Knobs 2 Stainless Steel Grease Filters (3 filters with 48" models) Heat Lamp (2 with 48" models) 2 Implement Rods, 4 Allen Screws and 4 Stand-offs 2 Grease Filter Trays (3 supports with 48" models.) Monogram Logo Nameplate Allen Wrench For Implement Rods HARDWARE PACKAGE Locate and check contents. Screws shown actual size.
Installation Preparation TOOLS AND MATERIALS REQUIRED (NOT SUPPLIED) Hammer Duct tape Electric or battery operated GULOO DQG ELWV Key Hole Saw :LUH FXWWHU stripper 10" round metal GXFW OHQJWK WR suit installation. 3HQFLO DQG WDSH PHDVXUH Safety glasses :LUH QXWV Spirit level 3KLOOLSV DQG IODW blade screwdrivers )ODVKOLJKW 3OLHUV Strain relief for junction cover. 9 +] RU $PS ZLUH ZLWK JURXQG 3URSHUO\ grounded branch circuit.
Advance Planning INSTALLATION CLEARANCES These vent hoods are designed to be installed onto a wall or beneath a soffit or cabinet. ,QVWDOO WKHVH KRRGV ´ 0LQ WR ´ 0D[ DERYH WKH cooking surface. NOTE: Clearances may vary due to type of cooking product and local codes. Check with local inspectors to be sure standard is applicable. Soffit Installation SOFFIT OPTIONAL DUCT COVER ACCESSORIES Standard decorative duct covers are available in ´ DQG ´ KHLJKWV 'XFW FRYHUV PD\ EH VWDFNHG LQ YDULRXV FRP
Advance Planning DETERMINE INSTALLATION HEIGHT, DUCT COVER ACCESSORIES These vent hoods must be installed 30” min. to 36” PD[ DERYH WKH VWDQGDUG ´ KLJK FRRNLQJ VXUIDFH ZKHQ installed over any professional style UDQJHWRS RU UDQJH 7KH H[DFW KRRG LQVWDOODWLRQ KHLJKW LV determined by the ceiling height. Actual Ceiling Height *Possible Hood Installation Height 6" Duct Covers 1 12" Duct Covers 7' 11" 35" 1. 0HDVXUH WKH H[DFW FHLOLQJ KHLJKW 8' 0" 30" 2.
Advance Planning ADVANCE PLANNING POWER SUPPLY Ductwork Planning IMPORTANT 3OHDVH UHDG FDUHIXOO\ • These vent hoods are equipped for 10” round GXFWZRUN )RU EHVW SHUIRUPDQFH XVH ´ URXQG ductwork on the 48” wide hoods. 30” and 36” hoods may be transitioned to 8” round. • This hood may be vented vertically through upper FDELQHWV VRIILW RU FHLOLQJ $ GXFW WUDQVLWLRQ SLHFH LV VXSSOLHG IRU YHUWLFDO H[KDXVW 8VH ORFDOO\ VXSSOLHG elbows to vent horizontally through the rear wall.
Installation Instructions STEP 1 DETERMINE HOOD, DUCTWORK AND WIRING LOCATIONS • Use a level to draw the cooktop centerline location. Draw the line to ceiling height. • Measure desired distance from the bottom of the hood to the cooking surface, 30” min. to 36” max. NOTE: If you are installing the hood with duct covers, be sure to read “Using Duct Cover Accessories” page 7. Exact installation height may be determined by use of one or more duct covers.
Installation Instructions STEP 2A INSTALL HOOD ONTO WALL IMPORTANT: Framing must be capable of supporting up to 150 lbs. SKIP THIS STEP IF INSTALLING BENEATH A SOFFIT OR CABINET, GO TO STEP 2B. • Locate at least 2 vertical studs at the wood support. )RU ´ PRGHOV LI YHUWLFDO VWXGV FDQQRW EH ORFDWHG then install 2 screws through the wood support into the VWXG WKDW LV ORFDWHG YHUWLFDOO\ DOLJQHG ZLWK WKH VFUHZV located ½” from the edge of the wood support.
Installation Instructions STEP 2B Alternate Mounting Method INSTALL HOOD TO SOFFIT OR BENEATH CABINETS IMPORTANT: Soffit framing must be capable of supporting up to 150 lbs. SKIP THIS STEP IF USING WALL MOUNTING METHOD 2" A 7-1/2" 10" Top View Front of Hood :KHQ QHFHVVDU\ WKH KRRG PD\ EH LQVWDOOHG VR WKDW LW LV supported by the soffit. 7KH VRIILW VKRXOG EH FRQVWUXFWHG ZLWK [ ¶V • Determine the installation location on the wall.
Installation Instructions STEP 3 CONNECT DUCTWORK STEP 5 INSTALL DUCT COVERS ,QVWDOO GXFWZRUN PDNLQJ FRQQHFWLRQV LQ GLUHFWLRQ RI airflow as illustrated. NOTE: )RU HDVLHU KDQGOLQJ UHPRYH FDUGERDUG LQVHUW after film is peeled off. • Secure joints in ductwork with sheetmetal screws. Remove protective film from duct covers. If more than RQH GXFW FRYHU LV XVHG VHFXUH HDFK SLHFH WRJHWKHU with screws provided. :UDS DOO GXFW MRLQWV ZLWK GXFW WDSH IRU DQ DLUWLJKW seal.
Installation Instructions STEP 6 INSTALL FILTERS 3ODFH ILOWHU GULS WUD\V LQWR WKH UHDU RI WKH KRRG STEP 7 INSTALL IMPLEMENT RODS Template for Monogram nameplate Monogram nameplate • Insert the grease filter into the opening and drop into the trays. Screw Stand-offs Into Hood Use Allen Wrench to Secure Rod to Stand-offs • Use a flat blade screwdriver to install stand-offs into the bottom of the hood. $OLJQ LPSOHPHQW URG WR VWDQG RIIV ZLWK WKH VFUHZ hole towards the inside of the hood.
Notes 16 31-2000859 Rev.
Notes 31-2000859 Rev.
NOTE: :KLOH SHUIRUPLQJ LQVWDOODWLRQV GHVFULEHG LQ WKLV ERRN safety glasses or goggles should be worn. )RU 0RQRJUDP® ORFDO VHUYLFH LQ \RXU DUHD YLVLW monogram.com or call 1.800.444.1845 NOTE: 3URGXFW LPSURYHPHQW LV D FRQWLQXLQJ HQGHDYRU DW 0RQRJUDP $SSOLDQFHV 7KHUHIRUH PDWHULDOV DSSHDUDQFH and specifications are subject to change without notice. 31-2000859 Rev.
