Spec Sheet

ZV36SSJSS – Monogram 36" Stainless Steel Professional Hood
Specification Revised 1/16
For answers to your Monogram, GE Profile
™
Series or GE
®
Series appliance questions, visit
our website at GEAppliances.com or call
GE Answer Center
®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
Using Duct Cover Accessories
To avoid unsightly gaps, plan the hood installation height for duct
cover use. Use the following formula to calculate the need for one
or more duct covers and to ensure a trouble-free installation.
We recommend that the vent hood and decorative duct cover
(if used) be on site before final framing and wall finishing. This will
help to accurately locate studs, ductwork and electrical service.
• Read these examples carefully to determine the need for one
or more 6" or 12" duct covers.
A = Countertop to ceiling height.
B = Gap at the top of the hood to the ceiling.
C = Hood installation height – Plus 18" hood height.
NOTE: Dia. C should be between 48" and 54" (for a 30" to 36"
installation height). Raise or lower the hood installation height
to allow use of one or more 6" or 12" duct covers.
A
C
B
Ceiling Height
A - B = C
18" Hood
Height
8 ft. Ceiling 9 ft. Ceiling
INSTALLATION EXAMPLES
10 ft. Ceiling
12"
24"
30"
30"
36"
30"
8 ft. ceilings: When the hood is installed 30"
above the cooking surface and there is no
soffit or upper cabinetry, order one 12" duct
cover accessory.
9 ft. ceilings: When the hood is installed 30"
above the cooking surface, order two 12"
duct cover accessories.
10 ft. ceilings: When the hood is installed
36" above the cooking surface, order three
12" and one 6" duct cover accessories.