Owner`s manual

Installation instructions
[STEP 91 INSTALL SHELF "ONLY"
, Remove shelf packaging and protective film.
, If installing the shelf alone, without the backguard, place
shelf against the bottom of the hood and mark the
screw hole locations "B" on the wall.
, Drill two 1/8" pilot holes.
, If the drill did not enter the studs, enlarge holes to 3/8".
, Insert the wall anchors into the enlarged holes. Remove
the screws from the wall anchors.
, Install 2 shoulder screws into holes "D" in the bottom of
the hood flange leaving 1/8" gap.
, Engage shoulder screws into the keg hole slots in the top
of the shelf. Slide the shelf towards the left to lock into
place.
, Install two 3/4" long machine screws through the bottom
of the shelf into the bottom hood flange location "E".
Holes !
for Shelf(B) :
i
I STEP 10 INSTALL IMPLEMENT RODS
Screw 0%,
Stand-offs
'_i
f0
UseAllen ,/
, /
',, Wrench to /
", Secure Rod /
"',. to Stand-offs ./
, Usea fiat blade screwdriver to install the stand-offs into
the bottom of the hood.
, Align the implement rod to the stand-offs with the screw
hole towards the inside of the hood. Secure the rod to
the stand-offs with the supplied Allen wrench.
, Follow the same procedure on the opposite side.
FINALIZE INSTALLATION
, Install the supplied infrared bulb(s).
, See the Owner's Manual for instructions to test
operation.