Owner`s manual

Installation instructions
STEP 3 CONNECT DUCTWORK
, Install ductwork, making connections in direction of
airflow as illustrated.
, Secure joints in ductwork with sheetmetal screws.
,Wrap all duct joints
with duct tape for
an airtight seal.
, Useduct tape to
seal the flange
connection. Reach
inside the hood and
push the damper
up to be sure it
moves freelg.
_>mP
Duct Tape
OverSea_
and Screw
Air Flow
Screw
Duct Tape_ _1
Over Transition
ISTEP 41 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WAR N ING: ,fhousewiring isnot2-wirewitha
ground wire, a ground must be provided bg the installer.
When house wiring is aluminum, be sure to use U.L.
approved anti-oxidant compound and aluminum-to-
copper connectors.
AVERTISSEM ENT- si,ecablagedela
maisonn'estpasdu type(_deux illsavecun fildeterre,
I'installateur dolt fournir un circuit de terre. Ouand les ills
de la maison sont en aluminium, il prendre soin d'utiliser
de la pSte antioxidation approuv6e par UL et des
connecteurs pour I'aluminium-cuivre.
A Remove
Junction Box
Cover
B Insert Power __'_,,
Conduit Thru '*_ _(
Strain Relief _ /'
and Tighten
iZ
Ground---_
C Use UL Liste,
Wire Nuts
White
_Black
R
, Usewire nuts to connect incoming ground to green,
white to white and black to black.
, Push wires into junction box and replace cover. Besure
wires are not pinched.
[STEP 5 INSTALL DUCT COVERS
Note: For easier handling, remove cardboard insert after
film is peeled off.
Remove protective film from duct covers. If more than
one duct cover is used, secure each piece together with
screws provided.
, Place the duct cover(s) on top of the hood.
, From inside the hood, secure the duct cover to the top
with the small Phillips head screws supplied with the
covers.
STEP 6] INSTALL MOTOR
Outlet
Attachment
Slot
/
J
Spiing
Clip
, From the inside of the hood, slip motor into the
attachment slot on the left.
, Rotate motor upwards until it snaps into the spring clip
on the right.
, Secure the motor to the hood with the machine screw
and lock washer. (Screw is marked with red or blue
paint.)
, Plug connector into the motor.
IMPORTANT: Connector
ends are designed to mate
onlg one wag. Match flat and
round connectors as shown.
Attachment
Screw
\
i
/'
,/'
Spring
Clip