Installation Instructions

5
Advance Planning
TOOLS AND MATERIALS REQUIRED
(not supplied)
• Tape measure
• Knife
• Spirit level
• Wire cutter
• Wire stripper
• Wire nuts
• Electric drill and 5/32" bit
• Phillips screwdriver
• Flat-blade screwdriver
• Hammer
• Pliers
• Safety glasses
• Tape to mount template
• Gloves to protect against sharp edges
• 120V, 60Hz., 15- or 20-Amp, 2 wire with ground, properly
grounded branch circuit
• Strain relief for junction cover
• Plumb bob
• Center punch
POWER SUPPLY
IMPORTANT – Please read carefully.
WARNING: FOR PERSONAL SAFETY, THIS
APPLIANCE MUST BE PROPERLY GROUNDED.
AVERTISSEMENT :
POUR DES RAISONS DE SÉCURITÉ, CET APPAREIL DOIT
ÊTRE CORRECTEMENT MIS À LA TERRE.
Remove house fuse or open circuit breaker before
beginning installation.
Do not use an extension cord or adapter plug with this
appliance. Follow National Electrical Code or prevailing
local codes and ordinances.
Electrical supply
This vent hood must be supplied with 120V, 60Hz,
connected to an individual, properly grounded branch
circuit, and protected by a 15- or 20-amp circuit breaker
or time-delay fuse.
• Wiring must be 2-wire with ground.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
• Route house wiring in the ceiling, as close to the
installation location as possible. Allow an additional
3-feet length from ceiling joists to reach the junction
box on the hood.
• Connect the wiring to the house wiring in accordance
with local codes.
Grounding instructions
The grounding conductor must be connected to
a ground metal, permanent wiring system, or an
equipment-grounding terminal or lead on the hood.
WARNING: The improper connection
of equipment-grounding conductor can result in a risk
of electric shock. Check with a qualied electrician or
service representative if you are in doubt whether the
appliance is properly grounded.
AVERTISSEMENT :
Le mauvais branchement du l de mise à la terre peut
causer un choc électrique. En cas de doute, consulter
un électricien qualié ou un technicien pour déterminer
si l’appareil est à la terre.