Installation Instructions

STEP 12 INSTALL FILTERS, FINALIZE INSTALLATION

• Tip the lter into the lower slots at the rear of the

opening. Lift the lter and pull the knob forward until the

lter rests on the slots.

• Make sure you have engaged the "Clean Filter Reminder

Switch" with the right side grease lter by checking to

see if the red light is glowing in the display. If the red

light is glowing, please adjust the lter until the red

indicator light turns o.

• Clean the hood with an approved stainless steel cleaner.

• Check hood operation. If the hood does not operate,

check that house wires have been connected securely

and that no wires have been damaged during

installation. Check the breaker or house fuse is turned

on.

Filter Slots