Installation Instructions

STEP 10 CONNECT ELECTRICAL

Verify that power is turned o at the source.

WARNING: If house wiring is not 2-wire

with a ground wire, a ground must be provided by the

installer. When house wiring is aluminum, be sure to use

UL-approved antioxidant compound and aluminum-to-

copper connectors.

AVERTISSEMENT : Si le câblage de

la maison n’est pas du type à deux ls avec un l de terre,

l’installateur doit fournir un circuit de terre. Quand les ls

de la maison sont en aluminium, il prendre soin d’utiliser

de la pâte antioxidation approuvée par UL et des con-

necteurs pour l’aluminium-cuivre.

• Install strain relief onto the knockout of the junction box

cover.

• Insert house wiring through strain relief and tighten.

• Connect white leads to branch circuit white lead.

• Connect black leads to branch circuit black lead.

• Connect green/yellow leads to branch circuit green or

bare ground lead.

• Secure all connections with wire nuts on each electrical

connector.

• Push wires into junction box and replace cover. Be sure

wires are not pinched.

STEP 11

SLIDE DUCT COVER DOWN

• Hold the decorative duct cover and remove the

decorative stop screw from the support frame. Dress

all wire harnesses out of the path of the duct cover

seating.

• Slide the lower duct cover down onto the hood.