Installation Instructions

13
Installation Instructions
STEP 8 INSTALL DECORATIVE DUCT COVERS
• Pretap or drive decorative screw into the screw holes
on the support frame. This will make screw installation
easier.
• Separate the two decorative duct covers.
• Select the inside cover (top), which has two screw holes
in the top.
• Slide the decorative duct cover over the support frame
and push to the ceiling.
• Attach to the hood support at the top with 2 supplied
decorative screws.
• Locate the third decorative screw in the hardware
package. Set aside.
• Slide the lower decorative duct over the installed upper
duct and push to the top.
• Install the decorative stop screw in the center hole of the
upper (inner) duct cover. The decorative screw will act as
a stop screw and prevent the lower decorative duct cover
from sliding down.
CAUTION: The stop screw must be installed.
Failure to do so could result in personal injury or damage
to the duct cover.
PRUDENCE : La vis supérieure doit être
en place, an d’éviter les blessures ou d’endommager le
capot antipoussière.
STEP 9 INSTALL HOOD
NOTE: AT LEAST THREE PEOPLE ARE REQUIRED TO
COMPLETE THIS INSTALLATION!
• Lift the hood up to the support frame. Carefully align the
hood mounting holes to the support frame holes and, at
the same time, the hood duct connector into the duct.
• Install screws through the hood and hood support.
• Check hood level in both directions.
• Check to be sure that the duct is positioned over the
hood connector.
• Seal the duct connection with duct tape.
NOTE: Do not drive screws through this duct connection.
Doing so will prevent proper damper operation.
Stop Screw
Apply Duct Tape
to Seal Duct
Connection
Install
4 Lock Washers
and 4 Machine Bolts
Bottom
Duct
Cover
Right
Side
Front
Front
Front