Installation Instructions

STEP 6 SECURE WIRING

• Route house wiring through the ceiling hole and pull a

length to reach the hood junction box, approximately 6"

below the support.

STEP 7 SIZE AND INSTALL

DUCTWORK

• Tape the wire to the left side of the frame support to

prevent damage during installation and service.

• Measure from house duct ange to bottom of support

frame (Dim. A).

– Add at least 1" for duct overlap at the top.

– Subtract 1-3/4" for hood insertion into the bottom of

the frame to determine required duct length.

• Cut the 8" duct length required.

NOTE: The bottom of the duct must be external (female)

connection to the top of the hood. The bottom end should

be ared slightly, to facilitate installation of the hood.

• Install duct up through support frames and attach to

house ducting with sheet metal screws.

• Seal the connection with duct tape.

Ceiling

Support

Frames

Tape

House

Wiring

Left Side

View