Installation Instructions

STEP 6 SECURE WIRING

•Route house wiring through the ceiling hole and

pull a length to reach the hood junction box,

approximately 6" below the support.

STEP 7 SIZE AND INSTALL

DUCTWORK

• Tape the wire to the left side of the frame

support to prevent damage during installation

and service.

Ceiling

Duct

Dim. A

Duct Connection

To Hood

Bottom Support

Frame Flange

House Duct

1-3/4"

Side

View

Support

Frame

Required

Duct

Length

•Measure from house duct flange to bottom of support

frame (Dim. A).

– Add at least 1" for duct overlap at the top.

– Subtract 1-3/4" for hood insertion into the bottom

of the frame to determine required duct length.

•Cut the 8" duct length required.

NOTE: The bottom of the duct must be external

(female) connection to the top of the hood. The

bottom end should be flared slightly, to facilitate

installation of the hood.

•Install duct up through support frames and attach to

house ducting with sheet metal screws.

•Seal the connection with duct tape.

Ceiling

Support

Frames

Tape

House

Wiring

Left Side

View