Quick Start Guide

31-49133-1

STEP 3 PREPARING UNIT FOR INSTALLATION

Ŷ Place the right hand unit in front of the installation

opening in a way that the unit is in front of the intended

installed location.

Ŷ If doors will be reversed after installing, the stabilization

bracket at the top hinge side of the case will need to

be moved to the opposite side of the case. Remove 4

Phillips head screws, rotate the stabilization bracket

and install on the opposite side of the case.

Ŷ Unpack the heater Unification Kit (ZUGC) and make

sure all of the components on the list are included.

Ŷ Install 4 bumper blocks by snapping them to the left

side of the case between the 2 units - 2 on the upper

section of the case wall and 2 on the lower.

Ŷ Install adhesive heater on the outside of the unit to

the left side of the case. Install heater 2” below the top

2 standoff blocks. Heater should be centered front to

back on the metal case. Ensure the heater connector

cord is toward the bottom of the unit when installed.

Ŷ Remove the left access cover by removing 4 (1/4”) hex

screws. The cover is located at the outside lower left

side of the case.

Ŷ Use clips to adhere loose wire tightly to side of case as

shown. Clean the side using rubbing alcohol to ensure

proper clip adhesion.

Installation Instructions - Dual Integrated Installation

Upper bumpers

Lower bumpers

Stabilization

Bracket

Ǝ

Adhesive

Heater

Clips

Hex

Screws

Left Access

Cover