Owner`s manual

Design Guide
3/4" OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may be
installed on trimmed models. The overlay panel must
be secured to a 1/4" thick backer panel which slides
into the uim. A spacer panel 0.10" thick must be
placed between the overlay and backer panel.
Assemble the panels with glue and screws.
• Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
• (]enter the spacer and backer panel on the overlay
panel and secure with glue and screws. Screws must
be countersunk into the backer panel.
Door
1/4"
Backer A
Panel _ _ Spacer
OverlayPanel
BackerPanel
ROTE:Left-to-right offset
is not always equal to
top-to-bottom offset.
.250" + .10" + .750" = 1.100"Total Panel Thickness
IMPORTANT NOTE - Dispenser Models
The refligerator is supplied with two dispenser trims,
one for flamed panels and one for overlay panels.
The overlay dispenser uim is designed to fit a total
panel thickness of 1.100".
• If the panel is less than 1.100" a noticeable gap may
be created around the dispenser uim.
• If the panel is more than 1.100" the dispenser trim
cannot be secured to the door.
See Dispenser Trim Fit Example, page 9.
• The overlay panel must be consuucted according to
the specifications shown to achieve the correct total
thickness.
• Alternative panel construc6on methods such as
securing a 3/4" panel to a 1/4" backer panel cannot
be used. Another method, rou6ng a 3/4" thick
panel on all sides cannot be used. These methods
will not result in the required 1.100" panel thickness.
When a raised panel design is to be used, a custom
middle rail is required. See page 9 for details.
Grille Panel
7
F
Dispenser
Cutout
Freezer FreshFood
Panel Panel
m
_D_ I_E_
DispenserCutout *Cut the dispenser opening after the backer, spacer and overlay
5!3 panels have been assembled.
IMPORTANTNOTE:Maximum total weight for the assembled
/8 panels:
• Fresh food door panel- 75Ibs.
• Freezer door panel- 53Ibs.
• Grille Panel- 18Ibs.
I" 94/8" _1
36" Side-by-Side(in inches)
1/4"BackerPanel 33-7/8 9 68-3/8 14-9/16 18-9/16
.10"SpacerPanel 33 8-3/8 67 13-1/4 17-1/4
3/4"OverlayPanel 34-1/8 9-1/4 68-5/8 14-13/16 18-13/16
42" Side-by-Side(in inches)
1/4"BackerPanel 39-7/8 9-1/2 68-3/8 14-9/16 24-9/16
.10"SpacerPanel 39 8-5/8 67 13-1/4 23-1/4
3/4"OverlayPanel 40-1/8 9-3/4 68-5/8 14-13/16 24-13/16
48" Side-by-Side(in inches)
1/4"BackerPanel 45-7/8 9-1/2 68-3/8 18-9/16 26-9/16
.10"SpacerPanel 45 8-5/8 67 17-1/4 25-1/4
3/4"OverlayPanel 46-1/8 9-3/4 68-5/8 18-13/16 26-13/16
8