Owner`s manual

Design Guide
1/4" FRAMED PANEL DIMENSIONS
If you choose to install flamed panels, they must be
cut to the dimensions shown. The panels will slide
into the flame on the (loot and grille.
Non-Dispenser Models
If the custom panel is less than 1/4" thick and it fits
loosely in the door frame it can be backed tap with
a piece of fillet material or foam rope to improve
the fit.
t
t
t
, Door
t
t
t
t
\\
\
\
\
I
\
\
\\
|_5/16"
L Trim
Reveal
............1/4"
Panel
IMPORTANTNOTE:Maximum total panel weight:
• Fresh food door panel-75 Ibs.
• Freezer door panel - 53Ibs.
• Grille Panel- 18Ibs.
IMPORTANT NOTE - Dispenser Models
The refligerator is supplied with two dispenser uims,
one for framed panels and one for overlay panels.
• If the panel is less than 0.250" thick a noticeable
gap may be created around the dispenser trim.
Foam rope may be applied on the door to improve
the fit.
• If the panel is more than 0.250" thick, the
dispenser trim cannot be secured to the (loot.
See Dispenser Trim Fit Example, page 9.
A DispenserCutout
I GrillePanel i
-- 154/8"
7
F
Dispenser _,
Cutout
Freezer FreshFood
Panel Panel
M
m
I_E_
Side-by-Side(ininches)
Theframed panel must be 1/4"nominal thickness
to fit the dispenser trim.
36"Models 33-7/8 9 68-3/8 14-9/16 18-9/16
42"Models 39-7/8 9-1/2 68-3/8 14-9/16 24-9/16
48"Models 45-7/8 9-1/2 68-3/8 18-9/16 26-9/16
7