Owner`s manual

Design Guide
THE INSTALLATION SPACE
36" Models12"
42" Models18"
48" Models20"
*FinishedWidth
/
_f
.... | Electrical _ 1
%//z"maxii ^ _ _,, i
831/2" miniI Area b i
Finished |I
Opening II 75" FromFloor
Ill to Bottom
Iq - 24" of Electrical
II Area
It 5"t WaterSupplY+5" 3 1/2"
i 1/2'
*The finished cutout width must be:
35-1/2" for 36" models
41-1/2" for 42" models
47-1/2" for 48" models
Water And Electrical Locations
The opening must be prepared with the electrical
and water supply located as shown.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Cutout depth beneath a soffit:
_qlen installed beneath a soffit, the soffit cannot
exceed the 24" installation depth shown. The top case
trim overlaps the bottom of the soffit.
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
Note: GFI (ground fault interrupter) is not
recommended.
• _rater line can enter the opening through the
floor or back wall. The water line should be 1/4"
O.D. copper robing or GE SmartConnect TM kit
between the cold water line and water connection
location, long enough to extend to the front of the
refligerator. Installation of an easily accessible shut
off valve in the water line is required.
DIMENSIONS AND CLEARANCES
25-3/8" FramedModels
25-3/4" StainlessSteelModels
35",41",or47" CaseDepth
i CaseWidth _..... _........_l * Shippingheight.The
i ..... refrigeratorcanbe
adjustedto fit into a
cutoutthat is 83-1/2"
rain.to 84-1/2"max.
•84" From height.Note that the
Floorto top casetrim at the
TopFrame front is 1/2"higher
andwill overlap
uppercabinetryor
soffit. Useleveling
legs andwheelsfor a
maximum1" height
adjustment.
.36",42",or 48"
Frameto Frame
DepthIncludingHandles:
25-7/8" FramedModels
27-3/4" StainlessSteelModels
Product Clearances
These refligerators are equipped with a 2 position
door stop. The factory set 130 ° door swing can be
adjusted to 90 ° if clearance to adjacent cabinets or
walls is resuicted.
130° DoorSwing 90° DoorSwing
23_.7/8''
Behind
'I'T
I c
3
4" Min.
to Wall
Models A B C
36" 13" 15" 20-5/8"
42" 13" 19" 26-5/8"
48" 15" 20" 28-5/8"
Allow minimum clearances for fleezer door
(Dimension A) and fresh food door (Dimension B)
for a flail 130 ° door swing and to allow for pan
removal.
4" minimum clearance is required when door swing
is adjusted to 90° . If the 90 ° door stop position is
used, pan access is maintained, but pan removal is
restricted.
See illusuafions pages 4 and 5 to determine
door swing interaction with adjacent cabinets or
countertops.