Owner`s manual

Installation Instructions
[STEP 9A INSTALL OVERLAY PANELS
.iiii
_" • hot
== {_0t
I
Install door panels:
• Open door to 90 °. Remove the 6 Phillips head screws
flom the door handle.
• Remove handle. Retain all screws.
• Remove 6 screws holding uiln, lift off uiln. Retain
screws.
• Slide overl W panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face of
the fleezer door. To avoid damage to the dispenseL
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the assembled fleezer panel into the bottom
channel and slide into the hinge side uiln.
• Reinstall the top tHin piece with screws.
• There are two sets of holes in the handle side trim.
Replace handle side tHin by installing the original
screws in the REAR screw holes.
• Secure the handle to the door using the FRONT screw
holes.
• Follow the same procedures to install the opposite
panel.
• Check to be sure handles are evenly aligned with each
other at the top. To adjust, loosen handle screws and
slide lap or down. Tighten screws.
Handle
Trim
Move
Forward
For3/4"
Panel
DoorTrim
Refrigerator
Door
Supplied Handle
Shown in Overlay
Panel Position
i,
' _ UseFrontHoles
/\\ /,
',, _ <_ to Secure Handle
............ UseRearHoles
to SecureTrim
Custom handles
If you are using custom handles, the handle must be
property secured to the panel before sliding the panel
into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Secure the door Uilns using both the FRONT and
REAR screw holes. Use pan head screws to secure the
tHin. A package of 12 exua pan head screws can be
found in the literanne package. Discard supplied
handles.
16