Owner`s manual

Installation Instructions
STEP 9 INSTALL FRAMED PANELS Goto Step9Afor OverlayPanels
!,
Install door panels:
• Open door to 90 °. Remove the 6 Phillips head screws
flom the door handle.
• Remove handle. Retain all screws.
• Remove 6 screws holding uim, lift off uim. Retain
screws.
• Slide flamed panel into the door trim.
Dispenser Models Only:
• The dispenser controls protrude beyond the face of
the freezer door. To avoid damage to the dispense_,
the trim at the top of the door should be removed.
• Remove the screws holding the top trim in place.
• Place the fleezer panel into the bottom channel and
slide into the hinge side trim.
• Reinstall the top trim piece with screws.
• There are two sets of holes in the handle side trim.
Replace handle side trim by installing the original
screws in the FRONT screw holes.
• Secure the handle to the door using the REAR screw
holes.
• Follow the same procedures to install the opposite
panel.
• Check to be sure handles are evenly aligned with each
other at the top. To adjust, loosen handle screws and
slide up or down. Tighten screws.
J
Handle
Trim-_
Supplied
Handle Shown
in 1/4"Panel
Position
DoorTrim
Refrigerator
Door
I_\\\\\\\\\\\\\\\\\\\\\1
/
p -
,o :i:i:i:i:il
'i iiiiiiiiiii
--/ UseFrontHoles
_\ _/ to Secure Trim
" .........-.... "Use Rear Holes
to Secure Handle
15