Owner`s manual

Installation Instructions
STEP 5 LEVEL REFRIGERATOR
All models have 4-point leveling. The fiont is
supported by leveling legs, the rear is supported by
adjustable wheels. Both are accessible flom the flont
of the refligerator.
• To level the back of the refligerato_; turn the
7/16" hex nut located above the flont wheels. Turn
clockwise to raise or counterclockwise to lower the
refligerator.
• For flont leveling, use a 1-1/4" open-end wrench.
• Adjust height of refligerator to match installation
cutout opening 83-1/2" to 84-1/2". The refligerator
should be level and plumb with cabineuy.
HexNutAd
RearWheels j_Leveling Leg
CAUTION:
The rear leveling wheels and flont leveling legs are
limited to a maximum height adjustment of 1". If the
installation requires more than 84-1/2" height, the
installer should elevate the refligerator on a sheet
of pl)_,vood or rtmners. Cabineuy uim could also be
added across the top of the opening to shorten the
opening. If you attempt to raise the refrigerator
more than 1", you will damage the front leveling
legs and the rear leveling wheels.
PRUDENCE
I,es roues de nivellement arri&re et les pattes de
nivellement avant permettent un r_glage maximal
de 25 mm (1 po). Si l'ouverture pour le r_flig_rateur
a une hauteur sup_rieure _'t2,15 m (84-1/2 po),
l'installateur dolt _lever le r_flig_rateur sur une
feuille de conue-plaqu_ ou des glissib.res. I1 est
_galement possible d'_{iouter des baguettes de
finidon des placards sur le haut de l'ouvermre afin
de la rdduire. Lever le r6frig6rateur de plus de 25
mm (1 po) endommage les pattes de nivellement
avant et les roues de nivellement arri6re.
STEP 6 SECURE REFRIGERATOR
TO CABINETRY
X4rhenever possible, perform this step for anti-tip
securiD_, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case uim.
• Drill hole in trim and drive screw through the trim
into adjacent cabinet.
• Follow the same procedure on the opposite side.
A
to Stop Position II / 1_11_
ThroughCaseTrimInto
AdjacentCabinets
STEP 7 ADJUST DOOR SWING
NOTE: This refligerator has a 2-position door stop.
_qlen space does not allow the door to swing open
flHly to 130 °, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
Interior'_
130°
Door
Hinge
• Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is facto_ T installed
in the 130 ° position.
• Close the dooL From below, use pliers to unscrew
the door stop and reinstall into the 90 ° position.
13