Owner`s manual

Installation Instructions
STEP 2 (continued)
• Turn on the main water supply and flush debris.
Run about a quart of water through the robing into
a bucket. Shut off water supply at the shuboff vane.
NOTE: Saddle type shut-off valves are included in
many water supply kits. Before purchasing, make
sure a saddle type vane complies with your local
plumbing codes.
NOTE: Commonwealth of Massaclmsetts Plumbing
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massaclmsetts.
Consult with your licensed plumbex.
[STEP 2A WATER LINE
INSTALLATION WITH A REVERSE
OSMOSIS SYSTEM
Skip this step when not using an RO System
If the water supply to the refiigerator is fiom a
Reverse Osmosis Water System use the refiigerator's
filter bypass plug. Using the refligerator's water
filuafion camidge with the RO filter can result
in hollow ice cubes.
Clockwise_b
STEP 3 INSTALL SIDE PANELS
Skip this step when not using side panels
If you are using 1/4" side panels, they should be
inserted into tim case trim. Fasten the panels to the
refligerator with s0ck-on hook and loop fastener
suips before setting refligerator in place.
STEP 4 INSTALL ANTI-TIP BRACKETS
WARNING:ANT,-T,PPRECAUT,ONS
The refiigerator is top-heax T and must be secured to
prevent the possibility of tipping forward.
ATTENTION:PRECAUTIONS CONTRE LES
BASCULEMENTS
I,e r_frig_rateur est beaucoup plus lourd en haut et il
faut le maintenir en place pour &qter la possibilit_ de
son basculement vers l'avant.
• Cut a 2" x 4" block, 35" long and secure the block to
the mounting brackets provided using #12 or #14
wood scxews.
2x4Cut ,_
35"Lengthi '_ '_
--,,¥ _¥
Installation Mounting "---_-
Height Bracket
FromFloor
ScrewsMountedinto J
VerticalWall Studs
• Secure the bracket with wood block to the back wall
so that it is 84" (or your installation height) flom
the finished floox. Use #112or #114wood screws.
See illustration.
m
Brackets
NotRequired
Beneatha
Soffit
Brackets
Required
SideView
• Screws must peneuate at least one inch into vertical
wall studs.
• Before pushing the refrigerator into the opening,
plug the power cord into the receptacle. Open the
grille panel and reach into the opening at the back
to grasp the power cord. Pull the power cord into
the opening as you push the refrigerator back.
• Gently push refrigerator into the opening with
hands against flont corners.
ImportantNote:Whenthe refrigeratoris installedundera soffit or if
there is not enoughheightfor this methodof security,bracketscannot
be used.Proceedto step5 to levelthe refrigeratorandthento step 6
to securerefrigeratorto cabinets.Therefrigeratormustbesecuredto
preventtipping.
12