Installation Guide

CUSTOMIZATION BASICS:
These refrigerators are designed to be customized with decorative panels. Field installed custom door and grille
panels are required.
7
Optional Accessory Kits
ZKHSS2: Monogram Tubular Stainless Steel handles
designed to fit 3/4” (1.91 cm) overlay panels.
ZKHPSS1: Professional Tubular Stainless Steel
handles designed to fit 3/4” (1.91 cm) overlay panels.
Kit includes one handle. Order 2 kits for side-by-side
refrigerator models from your Monogram supplier
Design Guide - Standard Installation
SIDE PANELS
Side panels must be used
whenever the sides of
the refrigerator will be
exposed. The 1/4”
(0.63 cm) side panels will
slip into the side case trim.
Secure the panels to the
refrigerator with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
* Depending on installation height.
*84"
2-9/16"
24"
*3" to 4"
3/16"
1-7/8"
REFRIGERATOR LOCATION
• Do not install the refrigerator where the
temperature will go below 55°F (13°C). It
will not run often enough to maintain proper
temperatures.
• Do not install the refrigerator where temperatures
will go above 100°F (37°C). It will not perform
properly.
• Do not install the refrigerator in a location
exposed to water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it
fully loaded.
31-49171