Installation Guide

CUSTOMIZATION BASICS:
These refrigerators are designed to be customized with decorative panels. Field installed custom door and grille
panels are required.
25
Optional Accessory Kits
ZKHSS2: Monogram Tubular Stainless Steel handles
designed to fit 3/4” (1.91 cm) overlay panels.
ZKHPSS1: Professional Tubular Stainless Steel
handles designed to fit 3/4” (1.91 cm) overlay panels.
Kit includes one handle. Order 2 kits for side-by-side
refrigerator models from your Monogram supplier
ZUG2: For side-by-side installation of two trimmed
models. This kit provides for the installation of a unified
custom grille panel to span the width of two units using
a framed or overlay panel.
Design Guide - Flush Installation
CUSTOM HANDLE DESIGN GUIDE
Custom handles must be used for flush installation. For
custom handle installation, counterbore holes in rear of
decorative panels must ensure 1/2” (1.27 cm) material
thickness remains for handle support.
NOTE: The counterbore must not exceed 1” (2.54 cm)
in diameter.
Minimum distance from handle
side edge to handle center
should be 1-1/4” (3.18 cm) as
shown.
1/4”
1/2”
3/4”
1-1/4”1-1/4”
REFRIGERATOR LOCATION
• Do not install the refrigerator where the
temperature will go below 55°F (13°C). It
will not run often enough to maintain proper
temperatures.
• Do not install the refrigerator where temperatures
will go above 100°F (37°C). It will not perform
properly.
• Do not install the refrigerator in a location
exposed to water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it
fully loaded.
SIDE PANELS
Side panels must be used
whenever the sides of
the refrigerator will be
exposed. The 1/4”
(0.63 cm) side panels will
slip into the side case trim.
Secure the panels to the
refrigerator with stick-on
hook and loop fastener
strips. Order the side
panels from the cabinet
manufacturer.
• Cut a notch in the top
front corner as shown
to allow clearance for
corner keys in the front
side trim.
* Depending on installation height.
*84"
2-9/16"
24"
*3" to 4"
3/16"
1-7/8"
7/8"
0.85"
1/2"
31-49171