Quick Specs

HELPFUL TIPS
For questions about your
appliance, please call 1-800-626-2000.
Product Specication Created 10/19
STANDARD INSTALLATION
PAGE 7 OF 14
DISPENSER TRIM
RAISED OVERLAY PANEL DESIGN ON DISPENSER MODELS
1/4" PANEL DISPENSER TRIM 3/4" OVERLAY PANEL DISPENSER TRIM
Freezer Door
1/4" Framed Panel
Ice/Water Dispenser
1/4"
Total
Thickness
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
3/4" Overlay Panel
Ice/Water Dispenser
1.10"
Total
Thickness
A B
14"
11 3/4"
1/4" Backer Panel
3/4" Overlay Panel
.10" Spacer
1.10"
Total
Thickness
D
C
DISPENSER TRIM SIDE VIEW CROSS SECTION
(SHOWING RAISED OVERLAY
WITH MIDDLE RAIL)
ese refrigerators are supplied with two
dispenser trims, one for framed panels
and one for overlay panels.
1/4" PANEL DISPENSER TRIM:
e framed panel must be 1/4" nominal
thickness to fit the dispenser trim.
• e dispenser trim fits over the custom
panel and snaps into the freezer door.
• If the panel is less than 0.250" thick, a
noticeable gap may be created around
the dispenser trim. Foam tape may be
applied on the door to improve the fit.
• If the panel is more than 0.250" thick,
the dispenser trim cannot be secured to
the door.
3/4" OVERLAY PANEL
DISPENSER TRIM:
e 3/4" overlay dispenser trim is designed
to fit a total panel thickness of 1.100".
• If the panel is less than 1.100" thick, a
noticeable gap may be created around
the dispenser trim.
• If the panel is more than 1.100" thick,
the dispenser trim cannot be secured to
the door.
• e overlay panel must be constructed
according to the specifications shown to
achieve the correct total thickness.
• Alternative panel construction methods
such as securing a 3/4" panel to a 1/4"
backer panel cannot be used. Another
method, routing a 3/4"-thick panel on
all sides, cannot be used. ese methods
will not result in the required
1.100" panel thickness.
• When a raised panel design is to be used,
a custom middle rail is required.
RAISED OVERLAY PANEL
DESIGN ON DISPENSER
MODELS:
When a raised panel design is to be used,
a custom wide middle rail is required to
accept the dispenser trim.
• e middle rail must be wide enough to
allow for the dispenser trim to overlap
the opening.
• e middle rail must be 1.10" total
thickness to accept the dispenser trim.