Quick Specifications

PAGE 7 OF 14
HELPFUL TIPS
For questions about your
appliance, please call 1-800-626-2000.
Product Specication Created 10/19
STANDARD INSTALLATION
DISPENSER TRIM
RAISED OVERLAY PANEL DESIGN ON DISPENSER MODELS
1/4" PANEL DISPENSER TRIM
3/4" OVERLAY PANEL DISPENSER TRIM
Freezer Door
1/4" Framed Panel
Ice/Water Dispenser
1/4"
Total
Thickness
Freezer Door
1/4" Backer Panel
.10" Spacer Panel
3/4" Overlay Panel
Ice/Water Dispenser
1.10"
Total
Thickness
A B
14"
11 3/4"
1/4" Backer Panel
3/4" Overlay Panel
.10" Spacer
1.10"
Total
Thickness
D
C
DISPENSER TRIM
ese refrigerators are supplied with
two dispenser trims, one for framed
panels and one for overlay panels.
1/4" PANEL DISPENSER TRIM:
e framed panel must be 1/4" nominal
thickness to fit the dispenser trim.
• e dispenser trim fits over the custom
panel and snaps into the freezer door.
• If the panel is less than 0.250" thick, a
noticeable gap may be created around
the dispenser trim. Foam tape may be
applied on the door to improve the fit.
• If the panel is more than 0.250" thick,
the dispenser trim cannot be secured
to the door.
3/4" OVERLAY PANEL
DISPENSER TRIM:
e 3/4" overlay dispenser trim is
designed to fit a total panel thickness
of 1.100".
• If the panel is less than 1.100" thick, a
noticeable gap may be created around
the dispenser trim.
• If the panel is more than 1.100" thick,
the dispenser trim cannot be secured
to the door.
• e overlay panel must be constructed
according to the specifications shown
to achieve the correct total thickness.
• Alternative panel construction
methods such as securing a 3/4" panel
to a 1/4" backer panel cannot be used.
Another method, routing a 3/4"-thick
panel on all sides, cannot be used.
ese methods will not result in the
required 1.100" panel thickness.
• When a raised panel design is to be
used, a custom middle rail is required.
RAISED OVERLAY PANEL
DESIGN ON DISPENSER
MODELS:
When a raised panel design is to be
used, a custom wide middle rail is
required to accept the dispenser trim.
• e middle rail must be wide enough
to allow for the dispenser trim to
overlap the opening.
• e middle rail must be 1.10" total
thickness to accept the dispenser trim.
SIDE VIEW CROSS SECTION
(SHOWING RAISED OVERLAY
WITH MIDDLE RAIL)