Use & care guide

ZKHSS1 for 1/4" Panels
Tubular Stainless Steel [-[;_nctles
Step2:
Match
Handle Extrusions
to Handle
See Step 2A
for Stainless
Steel panels
• Cut a piece of corrugated to use as a pad to protect
the panel finish. Use 1/2" thick section of plywood to
protect flooring when drilling.
• Place custom panels on the pad, appearance side
down.
Note: If panels are wood, be sure to note which end is
the top so that wood grain is in the correct direction on
both (or all 3) panels.
• On the back side of the panel - at the handle side,
measure and mark 1/4" below the top edge of the
panel with a pencil.
• Slip panels into new extrusion on the handle side of
the panels.
• Align the extrusion at the pencil mark, 1/4" below the
top of the panel.
• Follow the same procedure on the opposite panel.
• Tape the extrusions to the panels to prevent move-
ment.
• Center punch and drill 1/8" pilot holes through the
holes in the extrusion and into the panel.
• Turn panel over. On the appearance side, use 9/32" bit
to enlarge clearance hole.
IMPORTANT: Hole locations must be exact to accept handle
standoff and handle assembly.
For models with full width dispenser trim and 2 piece
freezer panels:
• Measure 1/4" from the top of the upper panel and 1/4"
from the bottom of the lower panel. Mark with pencil
on the back handle side.
• Align the extrusion on the pencil mark as shown, top
and bottom.
Note: Besure to orient
extrusions and handles
correctly. Thetop ends ofthe
extrusions are cutout to fit the
shapeof the top of the door,
\
AlignExtrusion
of Panel
i i i!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii ii!ii!ii!ii!ii!ii!ii!ii!ii!ii!i ii!!i ii ii iiii !ii!ii!ii!i!!i!!i!ii!!i!!i!! !!i!! !!ii!i!i i! !i !
:d
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
Models _ Freezer Fresh Food
With Full Width _Ext_us / Extrusion
DispenserTrim
Decorator
Door_/
Panel
_ j--Extrusion
39